Positively Eliminates Floor Squeaks
PRODUCTS ORDER DEALERS FAQ CONTACT NEW PRODUCTS
 
 

The MARRIAGE JOINT ADJUSTMENT BRACKET is specifically designed to create even, trouble-free marriage joints in double-wide manufactured homes.

It's quick, easy and cost effective to install

  • Install this product wherever there is a problem. Adjust the units evenly, rotating to avoid too much pressure on any one unit. To lessen the chance of movement and to provide for future adjustments, leave the units in place.
  • To install the Marriage Joint Adjustment Bracket you will need a Phillips head screwdriver and an adjustable wrench. Package contents include: two angles (one 3-1/2 x 5" /one 2-1/2" x 2"), one 3/4-16" x 5" threaded stud, four 3/4-16 jam nuts, and nine #12 x 1-1/2" screws.
Order Now

 
 
 
Three easy steps to even marriage joints

In problem areas slip pre-assembled bracket over the perimeter joists, at the marriage joint. Screw the large angle to the lower of the two joists. Screw the smaller angle to the higher joist (using 9 #12 x 1-1/2" screws provided).

Loosen nut no. 1 to allow for adjustment. Use wrench to tighten nut no. 2. As you tighten the nut, pressure is applied to both joists in the proper direction.

After adjusting, lock in place by tightening the nuts on both sides of the angle. To reduce the chance of movement, and to provide for future adjustments, leave brackets installed.

Safety Note:

Use proper safety precautions before installing the Marriage Joint Adjustment Bracket. Be cautious of the following hazards: Electrical cables, gas lines and plumbing pipes.

To ensure that nothing interferes with a successful installation of the Marriage Joint Adjustment Bracket, avoid areas like: Splintered or rotting floor materials, knots in application joints and insulation.