Positively Eliminates Floor Squeaks
PRODUCTS ORDER DEALERS FAQ CONTACT NEW PRODUCTS
 
 

The Seam-Ender eliminates unsightly seam pops. Specifically designed to create even, trouble-free marriage joints in double-wide manufactured homes.

  • Engineered to answer the needs of professionals in the manufactured housing industry the Seam-Ender is strong, economical and easy to install.
  • Only tools needed for installation are a Phillips head screwdriver, rubber mallet and an adjustable wrench.
  • For use on most sub-floors and floorboards supported by joists up to 2 x 10's.
  • Does not damage floor coverings...no need to rip up carpeting and vinyl.
  • Great for both on-site construction and manufactured homes.
  • Cost effective and is fast becoming the ONLY solution for contractors and builders nationwide.
Order Now


 
 
Four easy steps to ending uneven floor seams

From underside of floor, locate the exact position of the "Seam Pop" by having someone above tap on the floor with knuckles or rubber mallet, as to not damage floor covering.

Insert hanger bolts with head in concave of anchor plates. Position plates against joist on each side. Screw anchor plates
to floor.

Slip joist bracket over joist and hanger bolts. Install washers and hand tighten hex nuts onto hanger bolts.

Tighten nuts on each side of joist until seam becomes even. Be sure not to over tighten.